Polymer Nanocomposite-Based Wide Band Strain Sensor for 3D Force Measurement Using Piezoelectric and Piezoresistive Data Fusion

Ahmed Mohammed H. Al Otaibi, Purdue University

Abstract

Polymer nanocomposites (PNC) have an excellent potential for in-situ strain sensing applications in static and dynamic loading scenarios. These PNCs have a polymer matrix of polyvinylidene fluoride (PVDF) with a conductive filler of multi-walled carbon nanotubes (MWCNT) and have both piezoelectric and piezoresistive characteristics. Generally, this composite would accurately measure either low-frequency dynamic strain using piezoresistive characteristic or high-frequency dynamic strains using piezoelectric characteristics of the MWCNT/PVDF film sensor. Thus, the frequency bands of the strain sensor are limited to either piezoresistive or piezoelectric ranges. In this study, a novel weighted fusion technique, called Piezoresistive/Piezoelectric Fusion (PPF), is proposed to combine both piezoresistive and piezoelectric characteristics to capture the wide frequency bands of strain measurements in real-time. This fuzzy logic (FL)-based method combines the salient features (i.e., piezoresistive and piezoelectric) of the nanocomposite sensor via reasonably accurate models to extend the frequency range over a wider band. The FL determines the weight of each signal based on the error between the estimated measurements and the actual measurements. These weights indicate the contribution of each signal to the final fused measurement. The fuzzy inference system (FIS) was developed using both optimization and data clustering techniques. In addition, a type-2 FIS was utilized to overcome the model’s uncertainty limitations. The developed PPF methods were verified with experimental data at different dynamic frequencies that were obtained from existing literature. The fused measurements of the MWCNT/PVDF were found to correlate very well with the actual strain, and a high degree of accuracy was achieved by the subtractive clustering PPF’s FISs algorithm. 3D force sensors have proven their effectiveness and relevance for robotics applications. They have also been used in medical and physical therapy applications such as surgical robots and Instrument Assisted Soft Tissue Manipulation (IASTM). The 3D force sensors have been utilized in robot-assisted surgeries and modern physical therapy devices to monitor the 3D forces for improved performances. The 3D force sensor performance and specifications depend on different design parameters, such as the structural configuration, placement of the sensing elements, and load criterion. In this work, different bioinspired structure configurations have been investigated and analyzed to obtain the optimal 3D force sensor configuration in terms of structural integrity, compactness, the safety factor, and strain sensitivity. A Finite Element Analysis (FEA) simulation was used for the analysis to minimize the time of the development cycle. A tree branch design was used as the 3D force sensor’s elastic structure. The structure was made of aluminum with a laser-cutting fabrication process. The PVDF/MWCNT films contained piezoresistive and piezoelectric characteristics that allowed for static/low strain measurements and dynamic strain measurements, respectively. Two compositions with 0.1 wt % and 2 wt.% PVDF/MWCNT sensing elements were selected for piezoelectric and piezoresistive strain measurements, respectively. These characteristic measurements were investigated under different vibration rates in a supported beam experiment. The 3D force sensor was tested under dynamic excitation in the Z-direction and the X-direction. A Direct Piezoresistive/Piezoelectric Fusion (DPPF) method was developed by fusing the piezoresistive and piezoelectric measurements at a given frequency that overcomes the limited frequency ranges of each of the strain sensor characteristics.

Degree

Ph.D.

Advisors

Chiu, Purdue University.

Subject Area

Physical therapy|Morphology|Nanotechnology|Optics|Polymer chemistry|Therapy

COinS